Tomorrow I hope to post about my daughter's Halloween costume (and have it done!) but for now I'm bringing you part 1 of the saga of reupholstering
this most beautiful and comfortable chair to date. I am going to try to do it as much "by the book" as I can, using real upholstering techniques and upholstery fabric (NO lightweight cotton fabrics, even though they are cute and trendy).
 |
| Before |
Step 1 -- If you have an older piece of furniture upholstered with tacks,
buy a tack remover! It's all of about $3 (at Joann), but it is such a wonderful tool and saves so much time, effort and headache! I've even used it to help pry up staples that were in too deep to use pliers.
Step 2 -- Start removing tacks from the last piece to be put on the chair (usually the underside of the seat). Actually on a chair like this it doesn't really matter where you start since the sections are not overlapping each other. If I started on the seat or the back I would take off the gimp (or trim) first, then remove the tacks holding the fabric.
Note: Be sure to take LOTS of pictures to help you remember how to put things back together again, and how to layer the pieces of fabric to get a nice, clean finish...
...and the subtle folds that shape the fabric smoothly around corners and curves.
 |
| Horse hair stuffing -- a sign of quality |
Step 3 -- Carefully remove the fabric (you may want to keep the pieces to use as patterns to cut your new fabric, although if you do, make sure add a little extra around the edges so the piece isn't too small and difficult to staple). You can also keep the original stuffing (if it's not smelly or rotten) and use it again, with a fresh layer of Dacron (upholsterer's batting) on top.
 |
| Again, take lots of pictures of how things are put together |
Step 4 -- If your chair has springs, make sure and take many detailed pictures of how the springs are tied. This is very important for stability and strength in the seat.
Then remove the springs (and store them carefully so they don't get bent), and your chair should be... Just a wooden frame!
Step 5 -- Repair any structural issues. My chair was a little wobbly at the arms, both where they attached to the back and at the seat. I used wood glue (I've heard Gorilla Wood Glue is great for this, I personally have
not had good results Elmer's Wood Glue) and squirted it in the joints (being sure to wipe up any drips!), tied the arms together as a "clamp" to hold the arms where they should be while the glue dried. I had to keep checking back as the glue dried because there always seemed to be a new drip somewhere. Wipe them all up before they dry or else they will be a major pain to try and remove... Not that I would know that from experience or anything... !
 |
P.S. Wood glue soaks through newspaper... put down some plastic!
|
Keep checking back for part 2!
